As a key component of industrial heating equipment, the stable operation of the furnace transformer has a direct bearing on production efficiency and safety. The following are the key precautions for its use:
1. Load Matching
Strictly control the connected load according to the nameplate parameters, and avoid long-term overload, which could lead to winding overheating and aging. It is recommended to adopt a staged voltage-raising method at start-up to avoid transient inrush current that could damage the insulation layer.
2. Cooling System Management
Regularly check the unobstructed flow of the radiator/oil cooling system, and remove accumulated dust and oil stains; monitor the oil temperature indicator to ensure normal circulation of the cooling medium. In high-temperature environments, auxiliary ventilation facilities may be added.
3. Insulation Monitoring and Maintenance
Measure the insulation resistance between windings and to ground monthly with a megohmmeter (it should be ≥1 MΩ). If an abnormal drop is found, investigate moisture ingress or carbonization immediately. Pay special attention to the tightening condition of terminal connections, as looseness may cause partial discharge.
4. Environmental Protection Measures
Keep the installation area dry and well ventilated, away from corrosive gases and conductive dust. For mobile furnace transformers used outdoors, a rain cover should be provided and the desiccant replaced regularly.
5. Abnormality Response Mechanism
Install dual protection devices for overcurrent and overvoltage. When abnormal noise, smoke, or a sudden temperature rise occurs, cut off the power supply immediately and isolate the fault point. Opening the switch under load is prohibited, so as to avoid switching overvoltage that could break down the insulation.
Through standardized operating procedures and periodic maintenance, the service life of furnace transformers can be effectively extended and production safety ensured.



















