Causes Of Core Noise In Magnetic Voltage Regulators And Approaches To Noise Reduction

The noise generated by magnetic voltage regulators during operation originates from the core. Under the action of an alternating magnetic field, the dimensions of silicon steel sheets undergo slight changes—a phenomenon known as magnetostriction. Since the magnetostrictive variation cycle is half a period of the power frequency, the resulting body vibration has a fundamental frequency of twice the power frequency, manifesting as a continuous low-frequency hum. It can be said that the vibration of silicon steel sheets is mainly determined by the magnetostrictive properties of ferromagnetic materials.

The magnetostriction coefficient is not fixed; it is constrained by multiple factors. The first is the material of the silicon steel sheets: under the same magnetic field strength, silicon steel sheets of better quality exhibit lower magnetostriction and therefore lower noise, while a higher magnetostriction coefficient corresponds to higher noise. The second is the magnetic field strength itself: the stronger the magnetic field, the more pronounced the magnetostriction, and the greater the noise.

The surface condition and heat treatment process of silicon steel sheets are equally important. Whether the surface of the silicon steel sheets is coated affects magnetostriction—the coating adheres to the sheets and helps restrain their deformation, thereby reducing vibration. The effect of the annealing process is even more pronounced: under the same magnetic field strength, annealed silicon steel sheets show much lower magnetostriction than unannealed ones, because an optimized annealing process can reduce the magnetostriction coefficient severalfold.

In addition, besides material-related factors, the no-load noise of a transformer is also closely related to the condition of the core joints. The tightness and flatness of the joints directly affect the continuity of the magnetic circuit and, in turn, the noise level.

In summary, noise reduction for magnetic voltage regulators should start from three levels—materials, process, and structure: select high-quality silicon steel sheets with a low magnetostriction coefficient, optimize the annealing process to fully release internal stress, ensure the quality of surface coatings, and strictly control the manufacturing precision of core joints. These measures address noise at its source and represent a fundamental and effective path to reducing the noise of magnetic voltage regulators.


Inquiry Form

No file chosen
Supported formats: PDF (max 10MB)
  
Thank you. Your inquiry has been received. We will respond within 24 hours.